NTFS Graphical Utility

Hi Friends,

I am Sharing one small but very Good NTFS utility for GUI Lovers.

You can Handle your NTFS Partitions threw GUI in Fedora 9/10.

For this follow this command:-

yum -y install ntfs-config

after installing it you will able to see this option under System-> Administration -> NTFS Configuration Tool

Enjoy 🙂

Mounting NTFS Partition on RHEL 5.x

irst Setup RPMForge Repository by running this command :- wget http://apt.sw.be/redhat/el5/en/i386/RPMS.dag/rpmforge-release-0.3.6-1.el5.rf.i386.rpm

Install DAG’s GPG Key by executing following command:-
rpm – -import http://dag.wieers.com/rpm/packages/RPM-GPG-KEY.dag.txt

Verify the package you have downloaded:-
rpm -K rpmforge-release-0.3.6-1.el5.rf.*.rpm

Install the package :-

rpm -i rpmforge-release-0.3.6-1.el5.rf.*.rpm

or if you dont find packages here try some other repositories like rpmfusion, epel hope you will get it..

after this run yum list command if that runs completely
then Intall gcc packages from your RHEL CD/DVD or any other repository where gcc packages available.

GCC Packages is must for Mounting NTFS.

After GCC installed

run this command :-

yum -y install fuse fuse-ntfs-3g dkms dkms-fuse

if you are running xen kernel then only run this command

yum install kernel-xen-devel

if you are running PAE kernel then only run this command

yum install kernel-PAE-devel

Now Make Entry in your /etc/fstab file

make backup of your /etc/fstab by executing this command

cp /etc/fstab /etc/fstab.bkp

now open your /etc/fstab file in your favorite editor

vim /etc/fstab like below example

/dev/sda1          /mnt/ntfs      ntfs-3g      defaults       0  0


save & exit from file

Then execute this two commands in exact order

umount -a

mount -a

That’s it. Now You will able to see NTFS by executing df -kh or access your NTFS Volume from your mount point.